Circutor computer PLUS-TF Series Manual do Utilizador descarregar pdf (Página 34)

7.2.3 Plug & Play Step 3

 After configuring the power and capacitor steps configuration, the automatic setting can be launched. To

do so, select the Plug&Play option from the main menu (Fig.33) and press OK . The screen shown on

Fig. 34 will be displayed. Confirm the setting by pressing Do. Any steps connected will be shown on the

screen shown on Fig. 35 or, in case of the first setting, the screen on Fig.36 will be displayed.

Fig.33.- Launch the automatic Plug&Play setting

Fig.34.- To start Plug&Play, press Do

Fig.35.- Plug&Play in case there are steps

connected

Fig.36.- Start of Plug&Play

 From this point, the Plug&Play automatic setting will continue allocating the phases and the direction of

current transformers, allocating each transformer to its phase, while calculating the transformer ratio,

always assuming that In/5A transformers are used. The results of automatic adjustments are shown on

different screens, as shown on Fig.37 to 40.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 68 69

Sem comentários

Circutor computer PLUS-TF Series Manual do Utilizador Página 34