Circutor DHB Series Manual do Utilizador descarregar pdf (Página 8)

Fig. 3. Overall dimensions

Fig. 2. Meter fixing

4. INSTALLATION

The meter has separable strips with screw terminals, which enable the

connection of external wires of 2.5 mm

cross-section. Strips of input

signals are protected against any accidental disconnection by means

of a screw joint.

One must prepare a hole of 92

+0,6

´ 45

+0,6

mm in the panel, which the

thickness should not exceed 6 mm.

The meter is adapted to be mounted in a panel. The meter must be

introduced from the panel front with disconnected supply voltage. Be-

fore the insertion into the panel, one must check the correct placement

of the seal. After the insertion into the hole, fix the meter by means of

clamps (fig.2).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 45 46

Sem comentários

Circutor DHB Series Manual do Utilizador Página 8