Circutor CVMk2 Series Manual do Utilizador descarregar pdf (Página 28)

CVM

OPERATION

When power supply is connected to the CVMk2, the system will show an initial presentation

and initialize its internal software indicating the rmware version on the display screen. After a

time of searching, it will also display the rmware versions of the modules that are connected to

the COM 1 DISPLAY port as well as the cards that are inserted in each one of the modules.

Once initialization is complete, the CVMk2 will display the switched module's real time values

on the main screen.

The CVMk2 principal screen changes. This is because the system will keep a memory the

last screen that was viewed for more than 20 seconds before disconnected. This screen will

be displayed the next time the display is turn on except if it is an expansion card screen. They

are not stored in memory.

3.2. START-UP

Before power ON the device, make sure that all the cables are properly connected.

A bad connection can cause serious injuries to the personnel that are working on

the equipment and can damage the equipment.

Once the CVMk2 has been installed, is recommended to restart the meter and the

maximums and minimums of the device. It is possible that the installation process

will produce some recorded parameters outside the range of normal working and

subsequently affect the display of records in graphs or tables.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 151 152

Sem comentários

Circutor CVMk2 Series Manual do Utilizador Página 28