Circutor computer PLUS-TF Series Manual do Utilizador descarregar pdf (Página 41)

Fig. 50.- Transformer Ratio

Fig. 51.- Edit Transformer Ratio

 Press Edit and the screen shown on Fig.52 will be displayed. To edit a field, follow the procedure

described in section 5.4.

Fig. 52.- Transformer Ratio Menu

Fig. 53.- Edit Transformer Ratio Menu

 When the adjustment is complete, press OK to display the screen shown on Fig.53, indicating the cos 

of each phase and in the header, the kvar introduced in each phase in case it is started. The menu bar

shows the options to continue editing values when you press Edit. The unit will start-up when you press

Run . If the values measured seem correct, press Run. Otherwise, check for errors.

7.3.7 Adjusting the cos  objective

The cos  objective can be adjusted. To do so, follow this procedure:

 Open the setup menu by following the process described in section 7.3.2

 From the options menu, select Target cos φ (screen on Fig.54) and press OK . The screen shown on

Fig.55 will be displayed

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 68 69

Sem comentários

Circutor computer PLUS-TF Series Manual do Utilizador Página 41